#Point to point measure tool software
Further, it is used to measure the software project development along with its maintenance, consistently throughout the project irrespective of the tools and the technologies. The basic and primary objective of the functional point analysis is to measure and provide the software application functional size to the client, customer and the stakeholder on their request. However, functional point analysis may be used for the test estimation of the product.The functional size of the product is measured in the terms of the function point, which is a standard of measurement to measure the software application. FPA is used to make estimate of the software project, including its testing in the terms of functionality or function size of the software product. What is Functional Point Analysis?Ībbreviated as FPA, functional point analysis is one of the mostly preferred and widely used estimation technique used in the software engineering. The concept is all about the functional point analysis. But, did you know that an estimate of the software product including its testing could also be made in the terms of its functionality or functions. The information is not embedded in the actual image file.Whenever a software project comes, the organization usually try to make estimate of the project in the terms of cost and time, so that accordingly resources such as testers, tools, frameworks and time schedules for each phase of the project could be assessed and measured. If printing, emailing, or exporting an image that has measurements included, the measurement will not appear on the image once it is outside of the software. To Show/Hide the measurements: select View | Show Measurements.
Single click the measurement on the image and select the Delete key on the keyboard. Using the Selector tool the measurements can be deleted. However, if a new image is selected in the exam, the image must be calibrated for the software to produce an accurate measurement on the newly selected image. Changes can be made to the image after closing and reopening the image. At this time the calibration for this specific image has been saved. To save the measurements select File | Save. To move out of the Measurement mode, click on the Selector button on the tool bar or by choosing Tools | Selection. This will allow a new measurement to be taken. Once finished in the Measurement Information window, select OK. It is recommended to never uncheck this option.** **If the option Show Calibrated Measurements in the Measurement Information window is unchecked, the measurements may not be correct. The measurement on the image and in the Measurement Information window will show the total measurement from point A to point B but also the distance of each individual line. Once the measurement is complete, double-click the image to end measurement and the Measurement Information window will appear. Single click point to point throughout the image until the measurement is complete.The image has now been calibrated and the software will now move from Calibrate Mode to Measurement Mode. Type in the known distance of the object and select OK. The Calibrate Measurement window will appear.Drag the curser to the other side of the object and again, single click. Single click one side of the object in the image. The center of the crosshair is the point of reference. The Crosshairs will appear with a ruler to the side.From here select Tools | Calibrate Measurement.
0 kommentar(er)
